Edit participant

Note: Our support pages have been moved to our main SENS website. This content will no longer be updated here. For the latest updates, please refer to the following site. 

General

This article contains a guide to editing participants' information, including the monitoring period. "Participant" refers to the person wearing the SENS motion sensor.

To create a new participant, see this article.

Edit participant

To edit a participant's information, like name or monitor period, click the three dots to the right of a participant and select "Edit participant".

Select "Delete particpant" to delete a participant.

Participant information

Participant information contains information about the participant.

Particpant ID/First name does not need to be personally identifiable, and it is optional to enter last name and phone number.

"Timezone" describes the timezone in which the participant has worn the sensor.

Sensor information

"Measurement Method" is set to a standard algorithm by default. If you wish to use other algorithms or a dual sensor solution, please contact SENS.

Select or change a participant's sensor in the "Sensor on Thigh" drop down. Available sensors are marked with a green dot before the sensor ID and a green person after the sensor ID:

If you wish to have multiple measurements from different sensors connected to the same participant, you need another set-up, kindly contact support for further information. 

If a sensor's battery has run out during a measurement, or a sensor is lost during the monitor period, you must create a new "participant" and assign a new sensor. The data from the two sensors can then be concatenated during data processing.

Monitor period

Select the start- and end time for the monitor period in this modal. The period can always be adjusted, and the defined monitor period does not interfere with the stored data.

There are 3 options for selecting a start time:

For the end time you can select "Specify duration" in addition to the options above. Here you can specify the expected number of days, the measurement will last. When the measurement is complete you must adjust the monitor period accordingly.